PolyDie

PolyDie – Polycrystalline Diamond Wire Drawing Blanks

 

Polycrystalline diamond has long  used for the manufacture of wire drawing dies. The die blank is produced by High Temperature High Pressure sintering of micron sized diamonds to produce a solid disc of diamond within a supportive tungsten carbide ring. The polycrystalline nature of the diamond enhances its wear resistance and, unlike natural diamond, there is no preferred direction of wear or cleavage plane and, as result of the production process, the material is exceptionally tough.

The polycrystalline diamond is available in a range of grain sizes from 3 micron to 50 micron, depending on the application requirements. A finer diamond grain will allow a higher quality polish to be achieved during die manufacture and hence better surface finish on the drawn wire.

 In applications where surface finish is not the main criteria, coarser diamond grain structures will extend the die life.

 

 

PolyCrystalline Diamond

PolyCrystalline Diamond

 

 

 

 

The die blanks can be supplied with our without the tungsten carbide support ring. If unsupported the blanks can have a cross section that is either circular or hexagonal.

 

 

 

Supported die blanks are available up to 26.8mm diameter with a diamond core of 15mm diameter and 15mm deep; unsupported circular die blanks have a maximum diamond diameter of 16mm with a 12mm depth. The unsupported hexagonal blanks have a maximum diamond width of 5.2mm with a 3.5mm depth.